![]() ![]() With the engine running, remove the RIGHT spark plug wire. Now start the engine and get it warmed up. Turn the throttle screw on the LEFT CARB one half turn inward. Let the float bowl fill then start the engine. Put the rest of the CARB back together, clean the air filter and install the CARB. Now turn each screw one and one half turns outward. Only screw these in until they LIGHTLY seat. ![]() IMPORTANT > do not tighten these two screws down. Remove the idle screw and the air screw on the outside throat of the CARB and spray into the screw holes as well.īe sure to put these two screws back in the same hole they came out of. Spray into all the little airways and fittings in the CARB. Wear protective goggles to avoid getting spray in your eyes. Install new stock NGK spark plugs.įOR EACH CARB > Remove the float bowl and clean the entire CARB with a spray CARB cleaner from the auto parts store. Is there any water or trash in the cup? Dump it, clean it and re-mount it, (not all bikes have a water trap bowl). Is there any water or trash in the bowl? Drain a cup of gas from the tank. Remove the water trap bowl at the bottom of the petcock, (gas valve). Remove the screw then replace it after the fuel drains. There should be a screw on the lower side of each CARB float bowl. ![]()
0 Comments
Leave a Reply. |
Details
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |